Fail Open bridge setting is not shown in the configuration archive

Solution

Overview

Fail Open bridge setting is not shown in the configuration archive

The SG9000 platform disables the passthru-0 (ports 0:0 and 0:1) hardware bridge for management and leaves passthru-0:2 as the default fail-open mode.

When the archived configuration is generated, the global default mode for all hardware bridges is fail-open. Therefore the configuration for passthru-0 is considered non-default  and "mode disabled" is displayed.

!- BEGIN networking
interface 0:0 ;mode
ip-address 172.22.22.22 255.255.0.0
exit
interface 0:2 ;mode
label "WAN"
exit
interface 0:3 ;mode
label "LAN"
exit
bridge ;mode
edit "passthru-0"  ;mode
mode disable                          <<<<< disabled by default
failover mode serial
exit
edit "passthru-0:2"  ;mode
failover mode serial
exit
exit
dns-forwarding ; mode

Cause
Resolution

This has been addressed in SG 6.2.10.1 as B#177075 - The fail-open bridge setting for passthru-0 is now shown in the configuration archive.

 

Workaround

If the user archives a configuration with passthru-0 set to fail-open mode on the SG9000 platform, they will need to manually change the mode back to fail-open after the archived configuration is applied.

Workaround
Additional Information
Bug Number
InQuira Doc IdKB5251
Attachment

Article Feedback

Did this Article solve your issue?
Additional Comments:
 
Previous MonthNext Month
SunMonTueWedThuFriSat