How quickly does the ProxySG appliance fail-to-wire in a physically-inline deployment?

Solution

Overview

There are two main scenarios where the ProxySG appliance enters fail-over mode; each enter fail-over at different rates: 

System Power Loss: When a ProxySG appliance is configured to fail-open and all power is cut from the appliance (e.g. power outage or power cable removal), the built-in hardware relays should go immediately into fail-over mode.

System Hang: If the ProxySG appliance hangs instead of losing power, there might be a short delay (a maximum of 5 seconds) before the hardware bridge goes into fail-over mode. 

Cause
Resolution
Workaround
Additional Information
Bug Number
InQuira Doc IdFAQ1561
Attachment

Article Feedback

Did this Article solve your issue?
Additional Comments:
 
Previous MonthNext Month
SunMonTueWedThuFriSat