What is required to troubleshoot compression with a packetshaper running version 8?

<< Back to Knowledge Search



Please provide the following command output on both PacketShaper having compression enabled to troubleshoot compression v8.

ver ver
setup show
arp show
sys limit
sys set -nd
sys set showdebug 1
tunnel ip show                                                                                   <-- (Make sure the gateway MAC address is correct device)
tunnel com show
tunnel sum -pw
tunnel show all
tunnel local show  
tunnel remote show <tunnel name>                                                 <--Please key in the tunnel name
host show <IP address of the device inside the remote PS>              <--- Host IP address at remote site
tunnel discovery partner show
tunnel discovery host show
tunnel logging show <tunnel name>                                                 <--Please key in the tunnel name
tunnel debug compression
tunnel debug memory
hostdb info -n 50
sys flow -tupCIE -n 50
arp show
mib host
mib compression
sys l2cache show

 Before sending this to support team, please go through the basic troubleshooting at https://bto.bluecoat.com/packetguide/8.5/info/tunneltroubleshooting.htm.


Additional Information
Bug Number
InQuira Doc IdFAQ850

Article Feedback

Hide Properties
First Published      10/01/2014
Last Modified      10/01/2014
Last Published      10/01/2014
Article Audience
Product      PacketShaper
Topic      Configuration / WUI / CLI, Installation / Configuration
Article Number      000015276
Was this helpful?
Previous MonthNext Month